DIN 7990

Hexagon head bolts for structural steel bolting for supply with nut

English 1989
0.000
DIN
Detailed Information

This standard specifies requirements for M12 to M30 hexagon head bolts for supply with hexagon nut, assigned to product grade C, for use in structural steel bolting. These bolts shall always be used together with A type washers as specified in DIN 7989 (see clause 6).

Download File
(Log in to download spec.)

Check out other specifications

ASME
ASME B18.6.8
2010
English

THUMB SCREWS AND WING SCREWS (INCH SERIES)

This Standard covers the general and dimensional data for the various types of thumb screws and wing screws recognized as standard.
ASTM
ASTM A307
2010
English

CARBON STEEL BOLTS AND STUDS, 60,000 PSI TENSILE STRENGTH

1.1 This specification covers the chemical and mechanical requirements of three grades of carbon steel bolts and studs in sizes 1/4 in. through 4 in. The fasteners are designated by “Grade" den [...]
ANSI
ANSI B18.2.3.8M
1991
English

METRIC HEX LAG SCREWS

1.1 This standard covers the complete general and dimensional data for metric hex lag screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is [...]
DIN
DIN 1143-1
1982
English

Round plain head nails for use in automatic nailing machines

This standard specifies requirements for round plain head nails for use in automatic nailing machines.
ISO
ISO 888
1976
English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.
ASME
ASME B18.2.3.9M
1999
English

METRIC HEAVY HEX FLANGE SCREWS

This standard covers the complete dimensional and general data for metric series heavy hex flange screws recognized as American National Standard.
DIN EN
DIN EN 28744
1992
English

Full-length taper grooved pins (ISO 8744 : 1986) English version of DIN EN 28 744

This international Standard specifies the characteristics of full-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metr [...]
DIN
DIN 926
1986
English

Slotted set screws with full dog point

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN [...]
IFI
IFI-560
2007
English

TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS- METRIC SERIES

This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to metric series nuts, in nominal sizes M5 thru M20 intended for application [...]