DIN 916

Hexagon socket set screws with cup point – ISO 4029 modified

English 1980
0.000
DIN
Detailed Information

ISO 4029 specifies product grade A hexagon socket set screws with cup points with metric dimension and thread diameters from 1,6 up to and including 24 mm.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM F880
2008
English

STAINLESS STEEL SOCKET-SET SCREWS

1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW. 1.2 Units一The values stated in inch-pound units are to be regarded as standard. No other units of measurement are incl […]
DIN
DIN 315
1998
English

Wing nuts with rounded wings

This standard specifies requirements for M4 to M24 wing nuts with rounded wings, of product grade C and made of malleable cast iron, steel or copper-zinc alloy.
DIN
DIN 977
1998
English

Hexagon weld nuts with flange

This standard specifies requirements for hexagon weld nuts with flange, with size M5 to M16 metric threads (coarse) or 12 mm to 16 mm diameter threads (fine), of product grade A. Weld nuts conforming to this standard are suitable for use with bolts of property classes up to 10.9 (cf. DIN […]
DIN
DIN 59370
1978
English

Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights

This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.
ASTM
Abstract of ASTM F959M
1997
English

COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are c […]
DIN
DIN 440
1990
English

Washers for use in timber constructions

This standard specifies requirements for product grade C washers with a larger outside diameter. Such washers may be provided with a round hole (type R) for M5 to M52 bolts or a square hole (type V) for M5 to M22 bolts. The preferred application of these washers is in bolt/nut assemblies […]