Check out other specifications
2002
English
STRAIGHTNESS GAGING METHOD AND STRAIGHTNESS LIMITS FOR MACHINE, TAPPING, AND THREAD ROLLING SCREWS
This standard establishes a method for inspecting the out-of-straightness limits for machine, tapping, and thread rolling screws. Included are screws fully threaded or with thread lengths of at least 4D and screw lengths to and including 12 inches (D equals nominal screw diameter). For sc […]
2000
English
ALLOY STEEL SOCKET HEAD CAP SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1 - A complete metric companion to Specification ASTM A574 has been developed - A574M; therefore no me […]
2005
English
SLOTTED HEAD CAP SCREWS, SQUARE HEAD SET SCREWS, AND SLOTTED HEADLESS SET SCREWS (INCH SERIES)
This Standard covers the complete general and dimensional data for the various styles of slotted head cap screws and square head and slotted headless set screws recognized as “American National Standard." Also included are appendices covering thread runout sleeve gages for cap screws, pro […]
2008
English
ALLOY STEEL SOCKET-HEAD CAP SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement ar […]
2001
English
Corrosion Protective Coatings Phosphate/Organic/Oil Type
This specification covers basic requirements for a black corrosion protective coating which is produced in a process consisting of zinc phosphate treatment, chromic acid rinse or seal, organic coating, oven bake, water and oil emulsion post treatment and air dry.