DIN 918 Supplement 3

Overview of European Standards for fasteners

English 2001
0.000
DIN
Detailed Information

This Supplement reflects the most recent state of European standardization of fasteners by including:
a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1);
b) numerical indexes of DIN EN Standards (table 2) and DIN ISO Standards which have been given the status of a European Standard (table 3);
c) a numerical index of the DIN Standards and DIN ISO Standards replaced by EN Standards (table 4).

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 28674
1992
English

Hexagon nuts, style 2, with metric fine pitch thread – Product grades A and B (ISO 8674 :1988) English version of DIN EN 28 674

This International Standard gives specifications for hexagon nuts, style 2, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 36 mm, with product grad [...]
DIN
DIN 6883
1956
English

Taper Key Torque Transmission – Parallel Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]
DIN
DIN 6325
1971
German

Zylinderstifte, gehärtet – Toleranzfeld m6

Zylinderstifte nach dieser Norm werden hauptsächlich als Poßstifte für Werkzeuge, Spannzeuge und Meßzeuge verwendet.
JIS
JIS B 0202
1999
English

Parallel pipe threads

This standard specifies parallel pipe threads and is applicable to the threads used mainly for mechanical connection to joint the pipes, pipe fittings, fluid machinery, etc. The parallel inter [...]
ANSI
ANSI B18.22M
1990
English

METRIC PLAIN WASHERS

This standard covers general specifications and dimensions for flat, round hole washers, both soft (as fabricated) and hardened, intended for use in general purpose applications. The inclusion [...]
ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes [...]
DIN EN
DIN EN 10346
2009
English

Continuously hot-dip coated steel flat products – Technical delivery conditions – English version of DIN EN 10346:2009-07

This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming, of steels for construction, of steels with high proof strength [...]
NASM
NASM 51021
1998
English

SETSCREW-HEXAGON SOCKET, CUP POINT, CORROSION-RESISTING STEEL, PASSIVATED, UNC-3A, PLAIN AND SELF-LOCKING

SELF-LOCKING ELEMENT: (a) THE SELF-LOCKING ELEMENT SHALL BE IN ACCORDANCE WITH MIL-F-18240. (b) FOR DESIGN AND USAGE LIMITATIONS, SEE MS15981. (c) LOCATION OF EFFECTIVE LOCKING AREA SHALL BE IN [...]
JIS
JIS B 1117
1995
English

Slotted set screws

This Japanese Industrial Standard specifies the steel made slotted set screws (hereafter, referred to as "steel set screws"), and stainless steel made set screws (hereafter, referred to as "sta [...]