DIN 938

Studs – with a length of engagement equal to about 1 d

English 1995

0.000

Detailed Information

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in steel. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.

Download File

(Log in to download spec.)

Check out other specifications

ASTM

ASTM A563M

1997

English

Standard Specification for Carbon and Alloy Steel Nuts [Metric]

1.1 This specification covers chemical and mechanical requirements for eight property classes of hex and hex-flange carbon and alloy steel nuts for general structural and mechanical uses on bolts, studs, and other externally threaded parts. 1.2 Classes 8S3 and 10S3 nuts have atmospheric c […]

DIN EN

DIN EN 28839

1991

English

Mechanical properties of fasteners – Nonferrous metal bolts, screws, studs and nuts (ISO 8839 : 1986) (English version of DIN EN 28 839)

This International Standard specifies the mechanical properties of bolts, screws, studs and nuts - with nominal thread diameters, d, from M1,6 to M39 inclusive; - with metric ISO thread in accordance with ISO 261; - made of copper and copper alloys or aluminium and aluminium alloys. It d […]

ASME

ASME B18.8.4M

1994

English

SPRING PINS – SLOTTED [METRIC SERIES]

1.1.1 This standard is intended to cover the complete dimensions and mechanical and performance requirements for metric series slotted spring pins recognized as American National Standard, which are widely used in general industrial applications. Slotted spring pins have straight cylindri […]

DIN EN

DIN EN 28740

1992

English

Full-length parallel grooved pins, with chamfer (ISO 8740 : 1986) English version of DIN EN 28 740

This International Standard specifies the characteristics of full-length parallel grooved pins with chamfer which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with metric dimensions and nominal diameter, d1, from […]

ASTM

Abstract of ASTM A320/A320M

2010

English

ALLOY-STEEL AND STAINLESS STEEL BOLTING MATERIALS FOR LOW-TEMPERATUR SERVICE

1.1 This specification covers alloy steel bolting materials for pressure vessels, valves, flanges, and fittings for low-temperature service. See Specification A962/A962M for the definition of bolting. The bars shall be hot-wrought and may be further processed by centerless grinding or by […]

DIN

DIN 6900-3

1990

English

Screw and washer assemblies – Coarse threaded screws with captive curved spring lock washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M12 screw with flat bearing face, assigned to a property class below 8.8, and a captive curved spring lock washer (and also an optional plain washer). Curved spring lock washers are intended to c […]