DIN 939

Studs – with a length of engagement equal to about 1,25 d

English 1995

0.000

Detailed Information

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in cast iron. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 1544

1975

English

Plat Steel Products – Cold Rolled Steel Strip – Dimensions, Permissible Variations on Dimensions and Form

1.1. This Standard applies to cold rolled flat products ≥ 0.10 ≤ 6 mm thick without surface coatings, and in particular to cold rolled strip in rolling widths ≤ 650 mm and bars cut from such st [...]

ASTM

Abstract of ASTM F788/F788M

2008

English

SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS

This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat- [...]

ISO

ISO 1502

1978

English

ISO general purpose metric screw threads – Gauging

This International Standard gives the necessary instructions for the manufacture and use of gauges for checking ISO general purpose metric screw threads complying with ISO 68 and ISO 261. It i [...]

DIN

DIN 7967

1970

English

Self Locking Counter Nuts

When the self locking counter nuts have electrolytically deposited surface protection it is essential that suitable treatment methods should be adopted in order to prevent hydrogen embrittlement.

DIN

DIN 9021

1990

English

Large size washers

This standard specifies requirements for product grades A and C washers with a large outside diameter, i.e. washers with an outside diameter approximately equal to three times the nominal threa [...]

MIL

MIL-DTL-18240F

1997

English

FASTENER ELEMENT, SELF-LOCKING, THREADED FASTENER, 250°F MAXIMUM

This specification defines the requirements for self-locking elements for use in externally threaded fasteners such as bolts and screws to be used in fasteners with either UNC, UNJC, UNF, UNJF, [...]

ISO

ISO 7436

1983

English

Slotted set screws with cup point

This International Standard specifies the characteristics of slotted set screws with cup Point and thread sizes from M 1,6 to M 12 inclusive and product grade A

BS EN

BS EN 10025-4

2004

English

Hot rolled products of structural steels — Part 4: Technical delivery conditions for thermomechanical rolled weldable fine grain structural steels

Part 4 of this document, in addition to Part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the thermomechanical rolled condition in [...]

ANSI

ANSI B18.16.1M

1995

English

MECHANICAL AND PERFORMANCE REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL METRIC HEX NUTS AND HEX FLANGE NUTS

1.1 This standard covers the mechanical and performance requirements for prevailing torque type steel metric hex and hex flange nuts, - With hex nut nominal thread diameters M3 thru M36; - With [...]