DIN 96

Slotted round head wood screws

English 1986
0.000
DIN
Detailed Information

The following amendments have been made in comparison with the March 1975 edition.
a) Nominal lengths 90 mm and 100 mm have been deleted in order to bring this standard into line with the other standards on wood screws.
b) Type g has been replaced by product grade C.
c) The content of the standard his been revised.

Download File
(Log in to download spec.)

Check out other specifications

IFI
IFI-125
2007
English

TEST PROCEDURE FOR THE PERFORMANCE OF ADHESIVE COATED PREVAILING-TORQUE SCREWS

This standard establishes a conformance test procedure for the performance of adhesive coated prevailing-torque screws, in nominal screw sizes No. 4 thru 3/4 in. Torque values given in this st [...]
DIN EN
DIN EN 22341
1992
English

Clevis pins with head (ISO 2341 : 1986) English version of DIN EN 22 341

This International Standard specifies the characteristics of clevis pins with head, with metric dimensions and nominal diameters, d, from 3 to 100 mm inclusive.
DIN
DIN 928
2000
English

Square weld nuts

This standard specifies requirements for sizes M4 to M16 coarse and fine pitch thread square weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN E [...]
ASME
ASME B1.3M
1992
English

SCREW THREAD GAGING SYSTEMS FOR DIMENSIONAL ACCEPTABILITY OF METRIC SCREW THREADS

(a) This standard presents screw thread gaging systems suitable for determining the acceptability of UN, UNR. UNJ, M. and MJ screw threads on externally and internally threaded products. It est [...]
DIN
DIN 6913
1966
English

Spring Washers with Safety Ring

The surface of the spring washer and of the safety ring must be smooth and free from scale and burr. The spring washers must be coiled with constant pitch and without any kinks (with the excep [...]
DIN
DIN 966
1971
English

Cross Recessed Countersunk (Oval) Head Screws (Countersunk Heads according to ISO)

Normally these screws are made in the sizes for which weight details are given. If the screws are to be supplied with captive washer components, the designation must be augmented according to [...]
DIN
DIN 74361-2
1982
English

Disc wheels for motor vehicles and trailers – Fasteners for stud centring

This standard specifies requirements for fasteners for stud-centred disc wheels on motor vehicles and trailers. Any necessary draft on the hexagon shall be within the tolerance on the width acr [...]
DIN
DIN 6901
1990
English

Tapping screw and washer assemblies

This standard specifies requirements for screw and washer assemblies consisting of a tapping screw with f!at bearing face and a DIN 6903 captive washer
ISO
ISO 2903
1977
English

ISO metric trapezoidal screw threads – Tolerances

This International Standard specifies a tolerance system for metric trapezoidal screw threads according to ISO 2902. The tolerances refer to the basic profile according to ISO 2901. The tolera [...]