DIN 960

Sechskantschrauben – Metrisches Feingewinde – Ausführung m und mg

German 1970
0.000
DIN
Detailed Information

Eingeklammerte Größen sind möglichst zu vermeiden.
Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt. Technische Lieferbedingungen noch DIN 267

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F788/F788M
2008
English

SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS

This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat- [...]
DIN
DIN 525
1986
English

Weld studs

Weld studs are fasteners which are primarily selected because of their weldability. When determining what loadbearing capacity weld studs are to have, account shall be taken of their inherent s [...]
DIN EN
DIN EN 28736
1992
English

Unhardened taper pins with internal thread (ISO 8736 : 1986) English version of DIN EN 28 736

This International Standard specifies the characteristics of unhardened taper pins with internal thread, and metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
ASME
ASME Draft B18.2.7.1M
1999
English

METRIC 12-SPLlNE FLANGE SCREWS

1.1 This standard covers the complete general and dimensional data for metric 12-spline flange screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this sta [...]
ASTM
Abstract of ASTM F436M
1993
English

HARDENED STEEL WASHERS [METRIC]

1.1 This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M100. T [...]
DIN
DIN 80705
1990
English

Thin nuts with coarse pitch and fine pitch thread and with small widths across flats

This standard specifies requirements for thin nuts with small widths across flats and ISO metric screw thread as specified in the DIN 13 series, assigned to product grades B and C. If, in speci [...]
DIN
DIN 431
1982
English

Pipe nuts with thread in accordance with DIN ISO 228 Part 1

This standard gives specifications for (hexagon and octagon) pipe nuts with thread in accordance with DIN ISO 228 Part 1 of nominal sizes G 1/8 up to and including G 6, assigned to product grad [...]
ISO
ISO 272
1982
English

Fasteners — Hexagon products — Widths across flats

This International Standard specifies widths across flats for hexagon products, for example hexagon head bolts and screws, hexagon nuts and hexagon flanged bolts, screws and nuts, to be used in [...]
DIN
DIN 46241-2
1963
English

Telecommunications Engineering – Contact Rivets – Soldered or Welded – Technical Conditions of Delivery

These conditions of delivery apply to contact rivets according to DIN 46240 Sheet 2 with soldered-on or welded-on tip (at manufacturer's option) in contact materials which are not capable of be [...]