DIN 967

Product grade A cross recessed pan head screws with collar

English 1994
0.000
DIN
Detailed Information

This standard specifies requirements for M 3 to M 8 cross recessed pan head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or finishes. If, in special cases, screws are to comply with specifications other than those given in this standard (e.g. regarding property class or material), these shall be selected in accordance with the relevant standards.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F468M
1993
English

NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE [METRIC]

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number […]
ASTM
Abstract of ASTM F871M
1991
English

ELECTRODE POSITED COATINGS ON METRIC THREADED COMPONENTS

1.1 This specification covers dimensional requirements for electrodeposited coating on threaded fasteners with M metric threads. It establishes a service condition classification for these […]
DIN
DIN 472
1981
English

Circlips (retaining rings) for bores – Normal type and heavy type

Circlips within the meaning this standard are retaining rings for holding structural components (e.g. rolling bearings) in bores. They are given an eccentric shape, are fitted with spring r […]
ISO
ISO 725
1978
English

ISO inch screw threads – Basic dimensions

This International Standard specifies the basic dimensions, in inches, of ISO inch screw threads according to ISO 263, ISO inch screw threads - General plan and selection for screws, bolts […]
DIN
DIN 78
2001
English

Bolt end protrusions

This standard specifies minimum bolt end protrusions for general purpose assemblies of bolts, screws, studs and similar fasteners with ISO metric screw thread (coarse pitch thread) as in DI […]
ANSI ASME
ANSI/ASME B18.10
2000
English

TRACK BOLTS

All types of track bolts and nuts used by the various railroads and electric railways in the United States and Canada were studied by the committee, and it is their belief that the recommen […]
DIN EN
DIN EN 20898-1
1992
English

Mechanical properties of fasteners – Bolts, screws and studs (ISO 898-1 : 1988) English version of DIN EN 20 898 Part 1

This part of ISO 898 specifies the mechanical properties of bolts, screws and studs when tested at room temperature (see ISO 1) . Properties will vary at higher and lower temperature.
ISO
ISO 4759-2
1979
English

Tolerances for fasteners – Part II: Bolts, screws and nuts with thread diameters from 1 up to 3 mm and product grade F, for fine mechanics

This International Standard specifies the selection of tolerances for use in the preparation of ISO product standards for bolts, screws and nuts with thread diameters from 1 up to and inclu […]
DIN
DIN 471
1981
English

Circlips (retaining rings) for shafts – Normal type and heavy type

Circlips within the meaning of this standard are retaining rings for holding structural components (e.g. rolling bearings) on shafts. They are given an eccentric shape, are fitted with spri […]