DIN EN 10277-3

Blankstahlerzeugnisse – Technische Lieferbedingungen Teil 3: Automatenstähle – Deutsche Fassung EN 10277-3 : 1999

German 1999
0.000
DIN EN
Detailed Information

1.1 Dieser Teil von EN 10277 gilt für blanke, gerade Stäbe aus Automatenstählen Im gezogenen, geschälten oder geschliffenen Zustand.
1.2 Diese EN 10277-3 wird vervollständigt durch EN 10277-1.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 946
1991
English

Determination of coefficient of friction of bolt/nut assemblies under specified conditions

This standard specifies a tightening test for determining the coefficient of friction of bolt/nut assemblies under specified conditions. It is only applicable for comparison purposes, such as a comparison of assemblies with different surface finishes or for cases where different lubricant […]
IFI
IFI-128
2000
English

HEX COUPLING NUTS

1. All dimensions are in inches. 2. Top Surfaces of Nuts. Nuts shall be double chamfered. The diameter of chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The length of chamfer at hex corners shall be from 5 to 15 percent of the basic […]
SAE
SAE AS8879
2001
English

Screw Threads – UNJ Profile, Inch

This SAE Aerospace Standard (AS) specifies the characteristics of the UNJ profile inch series of screw threads, to include a mandatory controlled radius of 0.18142P to 0.15011P at the root of the external thread and with a minor diameter of both external and internal threads increased to […]
3.01
DIN
DIN 671
1981
English

Bright round steel – Dimensions Permissible deviations – according to ISO tolerance zone h9

This standard applies to bright round steel of nominal diameters from 1 to 150 mm, made of the steels listed in clause 5. Details as to finish and lengths to be delivered are given in clause 6.
IFI
IFI-166
2007
English

INSPECTION PROCEDUR FOR THREAD NICKS – INCH SERIES

This standard establishes an inspection procedure to determine acceptability of thread nicks as they relate to screw thread assemblability. This procedure is intended to be used for bolts, screws and studs of carbon or alloy steel #10 thru 1~ inch in diameter. This procedure applies to Un […]
BS EN ISO
BS EN ISO 2320
2008
English

Prevailing torque type steel nuts — Mechanical and performance properties (ISO 2320:2008)

This International Standard specifies the mechanical and performance properties for prevailing torque type steel nuts when tested at an ambient temperature range of +10 °C to +35 °C. It includes a single test to determine the prevailing torque properties (performance properties) and/or th […]