DIN EN 20898-2

Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2

English 1994
0.000
DIN EN
Detailed Information

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower temperature.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 2999-2
1973
English

Whitworth Pipe Threads for Tubes and Fittings – Cylindrical Internal Thread and Conical External Thread – Gauging System and Use of Gauges

The gauging system takes account of the function of the screwed joints and of practical installation requirements. The cylindrical internal thread is therefore gauged with a conical screw limit [...]
NASM
NASM 24671
1998
English

SCREW, CAP, SOCKET HEAD, FLAT COUNTERSUNK, 82°, CORROSION-RESISTING STEEL, UNC-3A

MATERIAL: STEEL CORROSION-RESISTING, IN ACCORDANCE WITH FED. STD No 66; AISI 302. 303. 304, 305. 316 OR 384 (DEVELOPED FOR COLD HEADING). MINIMUM ULTIMATE TENSILE STRENGTH SHALL BE 80.000 PSI F [...]
DIN EN
DIN EN 28738
1992
English

Plain washers for use with clevis pins, product grade A (ISO 8738 : 1986) English version of DIN EN 28 738

This International Standard specifies the characteristics of plain washers for clevis pins according to ISO 2340 and ISO 2341. Plain washers in accordance with this International Standard shal [...]
ISO
ISO 7093
1983
English

Plain washers – Large series – Product grades A and C

This International Standard lays down the specification for plain washers of product grades A and C with outside diameter three times nominal size (nominal thread diameter), preferable for hexa [...]
ISO
ISO 225
1983
English, French, Russian

Fasteners – Bolts, screws, studs and nuts – Symbols and designations of dimensions

This International Standard lays down the method of dimensioning bolts, screws, studs and nuts, recommended for use unless otherwise specified in the appropriate product Standards. It includes [...]
DIN
DIN 968
1994
English

Cross recessed pan head tapping screws with collar

This standard specifies requirements for ST 2,9 to ST 6,3 cross recessed pan head tapping screws with collar. See DIN 962 (or the standards referred to therein) for special screw types or finishes.
ISO
ISO 8992
1986
English

Fasteners — General requirements for bolts, screws, studs and nuts

This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requiremen [...]
DIN
DIN 918 Supplement 3
1999
English

Overview of European Standards for fasteners

This Supplement provides information relating to DIN 918 but no additional standard specifications.
DIN
DIN 5417
1976
English

Securing Parts for Rolling Bearings – Snap Rings for Bearings with Ring Groove

For connection with DIN 616 and ISO 464, see Explanations. This Standard specifies the dimensions of snap rings required for securing bearing with ring groove according to DIN 616, diameter se [...]