DIN EN 28734

Hardened parallel pins (ISO 8734 : 1987) English version of DIN EN 28 734

English 1992
0.000
DIN EN
Detailed Information

This International Standard specifies the characteristics of through hardened and case hardened parallel pins (dowel pins) with metric dimensions and nominal diameters, d, from 1 to 20 mm inclusive.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM F880M
1997
English

Standard Specification for Stainless Steel Socket Set Screws [Metric]

1.1 This specification covers the requirements for austenitic grade stainless steel socket set screws (SS5), sizes M 1.6 through M 24, having Property Classes A 1-50 and A 1-70.
DIN
DIN 928
2000
English

Square weld nuts

This standard specifies requirements for sizes M4 to M16 coarse and fine pitch thread square weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in D […]
DIN
DIN 662
1993
English

Oval-head rivets with nominal diameters from 1,6 to 6 mm

This standard specifies dimensions of steel and nonferrous metal oval-head rivets with nominal diameters from 1,6 to 6 mm.
ASTM
Abstract of ASTM A574M
1997
English

ALLOY STEEL SOCKET HEAD CAP SCREWS [METRIC)

1.1 This specification covers the requirements for quenched and tempered alloy steel socket head cap screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1220 MPa.
BS EN
BS EN 10025-6
2009
English

Hot rolled products of structural steels — Part 6: Technical delivery conditions for flat products of high yield strength structural steels in the quenched and tempered condition

Part 6 of this document, in addition to part 1, specifies requirements for flat products of high yield strength alloy special steels. The grades and qualities are given in Tables 2 to 4 (ch […]
ASTM
ASTM F436M
1993
English

Standard Specification for Hardened Steel Washers [Metric]

1.1 This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M10 […]
ISO
ISO 8677
1986
English

Cup head square neck bolts with large head – Product grade C

This International Standard specifies the characteristics of cup head square neck bolts with large head, with metric dimensions and thread sizes from M5 to M20 inclusive, of product grade C.
ASTM
ASTM F1077
1995
English

Standard Guide for Selection of Committee F-16 Fastener Specifications

1.1 This guide is intended to provide a rapid, easy to use method for identifying Committee F-16 fastener specifications and their applicable marking requirements.
DIN
DIN 316
1983
English

Wing screws

In June 1975, drafts of the planned new editions of DIN 315 (wing nuts) and of DIN 316 (wing screws) were published; they made a distinction between Part 1 "heavy duty type" and Part 2 "lig […]