DIN EN 28748
Coiled, heavy duty spring-type straight pins (ISO 8748 : 1987) English version of DIN EN 28 748
English
1992
0.000
Detailed Information
This International Standard specifies the characteristics of heavy duty coiled spring-type straight pins with metric dimensions and nominal diameters, d1, from 1,5 to 20 mm inclusive.
Download File
(Log in to download spec.)
Check out other specifications
1956
English
Taper Key Torque Transmission – Saddle Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
1981
English
Specification for ISO metric screw threads — Part 1: Principles and basic data
This Part of this British Standard specifies the principles and basic data for single-start, parallel screw threads having the ISO basic profile for triangular screw threads. Data for 1,0 mm to 300 mm diameter threads is tabulated and Appendix B is included giving the information necessar […]
3.01
2010
English
Standard Specification for Carbon and Alloy Steel Nuts for Bolts for High Pressure or High Temperature Service, or Both
1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1⁄4 through 4 in. and metric M6 through M100 nominal. It also covers austenitic stainless steel nuts in the size range 1⁄4 in. and M6 nominal and above. These nuts are intended […]
2001
English
Fasteners—Electroplated coatings
This Standard specifies dimensional requirements for electroplated fasteners of steel or copper alloy. It specifies coating thicknesses and gives recommendations for hydrogen embrittlement relief for fasteners with high tensile strength or hardness and for surface-hardened fasteners. Thi […]
2000
English
HEX COUPLING NUTS
1. All dimensions are in inches. 2. Top Surfaces of Nuts. Nuts shall be double chamfered. The diameter of chamfer circle shall be equal to the maximum width across flats within a tolerance of minus 15 percent. The length of chamfer at hex corners shall be from 5 to 15 percent of the basic […]