Ford | WX100

FINISH SPECIFICATION

English 2008
0.000
Custom
Detailed Information

The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Office for direction.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 926
1986
English

Slotted set screws with full dog point

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN [...]
DIN
DIN 6913
1966
English

Spring Washers with Safety Ring

The surface of the spring washer and of the safety ring must be smooth and free from scale and burr. The spring washers must be coiled with constant pitch and without any kinks (with the excep [...]
DIN
DIN 8195
1977
English

Design and selection of chain drives

1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and [...]
DIN EN
DIN EN 24034
1992
English

Hexagon nuts – Product grade C (ISO 4034 : 1986) English version of DIN EN 24 034

This International Standard gives specifications for hexagon nuts . with thread diameters from M5 to M64 inclusive and product grade C.
DIN
DIN 6797
1988
English

Toothed lock washers

The main purpose of toothed lock washers is to permit the flow of electric current between components coated by varnish, anti-corrosive agents or similar materials, the bent ends of the washers [...]
JIS
JIS B 1091
2003
English

Fasteners—Acceptance inspection

This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases wh [...]