Check out other specifications
2011
English
Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) […]
1961
English
Rod Ends and Clevis Pins
The following publications form a part of the specification to the extend specified herein. Unless otherwise indicated the latest revision of SAE publications shall apply. SAE J1010-Emission Control Hose SAE J1111-Component Nomenclature-Skidder-Grapple
2008
English
SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS
This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat-treated machine screws, tapping screws, and sems (the washers of screw-washer assemblies are exc […]
1990
English
Countersunk flat head screws – Part 2: Penetration depth of cross recesses
This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).
1981
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Aufweitversuch für Muttern
1 Geltungsbereich Diese Norm ergänzt DIN 267 Teil 1 und Teil 4, sowie DIN lSO 898 Teil 2 und enthält Festlegungen über einen Aufweitversuch für Muttern mit Festigkeitsklassen nach DIN ISO 898 Teil 2 und DIN 267 Teil 4 mit Gewindedurchmessern von 3 bis 39 mm. 2 Zweck Der Aufweitversuch na […]