IFI-134

MULTI-GRIP FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS

English 2008
0.000
IFI
Detailed Information

This standard establishes the dimensional, mechanical and performance requirements of multi-grip flush break, positive lock pull mandrel self-plugging blind rivets suitable for use in joining the component parts of assemblies of varying grip range where structural integrity is a design requirement.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 1816
1971
English

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Part 4
ASTM
Abstract of ASTM F468M
1993
English

NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE [METRIC]

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of a [...]
DIN EN
DIN EN 26157-1
1991
English

Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)

1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nomi [...]
ISO
ISO 965-3
1980
English

ISO general purpose metric screw threads – Tolerances – Part 3 : Deviations for constructional threads

This International Standard specifies deviations for pitch and crest diameters for ISO general purpose metric screw threads conforming to ISO 261, ISO general purpose metric screw threads - Gen [...]
ISO
ISO 1234
1976
English

Split pins – Metric series

This International Standard specifies the dimensions of split pins of the metric series.
DIN
DIN 258
1977
English

Taper Pins with Thread Ends and Constant Taper Lengths

As part of the work of Technical Committee ISO/TC 2, ISO standards for parallel pins and taper pins have been drawn up which necessitated a general revision of existing DIN standards. In that p [...]
DIN
DIN 188
1987
English

T-head bolts with double nib

This standard specifies M 8 to M 80 X 6 T-·head bolts with double nib. They are designed for use in attaching components to foundations or similar structures by means of T-slots, such as are sp [...]
DIN
DIN 6900-2
1990
English

Screw and washer assemblies – Coarse threaded screws with captive wave spring washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M10 screw with flat bearing face, assigned to a property class below 5.8, and a captive wave spring [...]
IFI
IFI-124
2007
English

TEST PROCEDURE FOR THE PERFORMANCE OF NONMETALLIC RESISTANT ELEMENT PREVAILING-TORQUE SCREWS

This standard establishes a conformance test procedure for the performance of Nonmetallic Resistant Element Prevailing-Torque Screws (hereinafter called "REPT screw"), in nominal screw sizes No [...]