IFI-142

HYDROGEN EMBRITTLEMENT RISK MANAGEMENT

English 1997
0.000
IFI
Detailed Information

This technical update provides a review of concepts to manage and minimize the risk of hydrogen embrittlement in electroplated screws. These concepts do not assure elimination of failure resulting from hydrogen embrittlement, but seek to manage that risk through minimization and setting forth those practices which have historically been thought to reduce probable embrittlement failure.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 8015
2011
English

Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules

This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) […]
DIN
DIN 7341
1977
English

Rivet Pins

St = 9 SMnPb 28K according to DIN 1651 or St 50 K + G according to DIN 1652 at manufacturer's choice; if a specific material is required, this is to be agreed.
SAE
SAE J493
1961
English

Rod Ends and Clevis Pins

The following publications form a part of the specification to the extend specified herein. Unless otherwise indicated the latest revision of SAE publications shall apply. SAE J1010-Emission Control Hose SAE J1111-Component Nomenclature-Skidder-Grapple
ASTM
Abstract of ASTM F788/F788M
2008
English

SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS

This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolt, screws, and studs, including heat-treated machine screws, tapping screws, and sems (the washers of screw-washer assemblies are exc […]
ISO
ISO 7721-2
1990
English

Countersunk flat head screws – Part 2: Penetration depth of cross recesses

This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).
DIN
DIN 267-21
1981
German

Mechanische Verbindungselemente – Technische Lieferbedingungen – Aufweitversuch für Muttern

1 Geltungsbereich Diese Norm ergänzt DIN 267 Teil 1 und Teil 4, sowie DIN lSO 898 Teil 2 und enthält Festlegungen über einen Aufweitversuch für Muttern mit Festigkeitsklassen nach DIN ISO 898 Teil 2 und DIN 267 Teil 4 mit Gewindedurchmessern von 3 bis 39 mm. 2 Zweck Der Aufweitversuch na […]