IFI-505

METRIC BREAK MANDREL BLIND RIVETS

English 1999

0.000

Detailed Information

This standard establishes the dimensional, mechanical, and performance requirements of metric break mandrel blind rivets
suitable for use in joining the component parts of an assembly.

Download File

(Log in to download spec.)

Check out other specifications

ASME

ASME B18.2.3.10M

1996

English

SQUARE HEAD BOLTS [METRIC SERIES]

This standard covers the general and dimensional data for standard metric series square head bolts.

DIN

DIN 933

1987

English

M 1,6 to M 52 hexagon head screws threaded up to the head – Product grades A and B

This standard specifies requirements for M1,6 to M52 hexagon head screws threaded up to the head, assigned to product grade A, for sizes up to M24 and length not exceeding 10d or 150mm, and to product grade B for sizes greater than M24 or length exceeding 10d or 150mm.

DIN

DIN 50150

1976

English

Testing of Steel and Cast Steel – Conversion Table for Vickers Hardness, Brinell Hardness, Rockwell Hardness and Tensile Strength

The conversion table In this Standard applies - to hardness values determined according to the following standards: ~DIN 50 103 Part 1 and Part 2 (Rockwell) ~DIN 50 133 Part 1 (Vickers) and ~DIN 50 351 (Brinell) - to tensile strength values determined according t.o ~DIN 50145 and - to val […]

ISO

ISO 7417

1984

English

Hexagon nuts for structural bolting – Style 2, hot-dip galvanized (oversize tapped) – Product grade A – Property class 9

This International Standard gives specifications for hexagon nuts, style 2, with metric dimensions, property class 9 hot-dip galvanized in accordance with ISO 1461 and tapped oversize to tolerance class 6AX. This International Standard covers product grade A nuts in thread diameters from […]

DIN

DIN 6900-2

1990

English

Screw and washer assemblies – Coarse threaded screws with captive wave spring washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M10 screw with flat bearing face, assigned to a property class below 5.8, and a captive wave spring washer (and also an optional plain washer). Wave spring washers are intended to counteract loos […]

NASM

NASM 35307

1999

English

SCREW, CAP, HEXAGON HEAD (FINISHED HEXAGON BOLT), STEEL, CORROSION RESISTING, PASSIVATED, UNC-2A

MECHANICAL PROPERTIES: The minimum tensile strength in load pounds, indicated in Table I is based on 80,000 PSI Minimum Tensile Strength for diameters through .625 inch and 70,000 PSI Minimum Tensile Strength for diameters over .625 inch. The yield strength, based on 2 percent offset, sha […]