IFI-520

METRIC PULL THROUGH MANDREL BLIND RIVETS

English 1999
0.000
IFI
Detailed Information

This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind
rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F467
2001
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this s […]
DIN
DIN 662
1993
English

Oval-head rivets with nominal diameters from 1,6 to 6 mm

This standard specifies dimensions of steel and nonferrous metal oval-head rivets with nominal diameters from 1,6 to 6 mm.
DIN
DIN 471
1981
English

Circlips (retaining rings) for shafts – Normal type and heavy type

Circlips within the meaning of this standard are retaining rings for holding structural components (e.g. rolling bearings) on shafts. They are given an eccentric shape, are fitted with spring retention in grooves and are suitable for the transmission of axial forces.
DIN
DIN 797
1970
English

Special Foundation Bolts

Strength category (material): 3.6 according to DIN 267 Part 3 Other strength categories or materials by agreement
DIN
DIN 7349
1974
English

Plain Washers – for Bolts with Heavy Clamping Sleeves

For heavy clamping sleeves, see DIN 1481.
DIN
DIN 705
1955
English

Bright Set Collars, Locked by Grub Screws or by Pins, Light Pattern Series

Set collars to Type A are furnished with grub screw to DIN 553.