IFI-530

METRIC STRUCTURAL SPLITTING SELF-PLUGGING PULL MANDREL BLIND RIVETS

English 1999

0.000

Detailed Information

This standard establishes the dimensional, mechanical, and performance requirements for metric structural splitting self-plugging pull mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.

Download File

(Log in to download spec.)

Check out other specifications

SAE

Abstract of SAE J429

1999

English

MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS

This SAE standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, SEMS, and U-bolts used in automotive and related industries in sizes to 1-1/2 in. inclusive. The term "stud" as referred to herein applies to a cylindrical rod of moderate length […]

DIN EN 28675

1992

English

Hexagon thin nuts with metric fine pitch thread – Product grades A and B (ISO 8675 :1988) English version of DIN EN 28675

This International Standard gives specifications for hexagon thin nuts, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade A for sizes d up to and including 16 mm and product grade B for sizes d over 16 mm.

DIN EN

DIN EN 14399-4

2006

English

High-strength structural bolting assemblies for preloading – Part 4: System HV – Hexagon bolt and nut assemblies – English version of DIN EN 14399-4:2006-06

This document specifies together with EN 14399-1 the requirements for assemblies of high-strength structural bolts and nuts of system HV suitable for preloaded joints with large widths across flats, thread sizes M 12 to M 36 and property classes 10.9/10. Bolt and nut assemblies to this d […]

DIN

DIN 1158

1973

English

Wall hooks

Wall hooks shall be made of steel (grade at manufacturer's discretion) and have a bright finish (bk).

DIN

DIN 6913

1966

English

Spring Washers with Safety Ring

The surface of the spring washer and of the safety ring must be smooth and free from scale and burr. The spring washers must be coiled with constant pitch and without any kinks (with the exception of the barbing of the ends). The ends of the spring washer which bite into the parent mater […]

DIN

DIN 7985

1972

English

Recessed Raised Cheese (Fillister) Head Screws

Normally, these screws are manufactured in the sizes for which weight details are given. If the screws are to be supplied with captive washer components, the designation must be augmented according to DIN 6900. Recesses and depth gauges according to DIN 7962.