IFI-544
METRIC ROUND HEAD RIBBED NECK BOLTS
English
1998
0.000
Detailed Information
This standard covers the complete general and dimensional data for metric series round head ribbed neck bolts in sizes M5 thru M14, intended for general engineering applications.
Download File
(Log in to download spec.)
Check out other specifications
1983
English
External tab washers (Locking tab washers)
This standard specifies requirements for external tab washers (previously known as locking tab washers), which are used in threaded fastenings. They are intended to prevent the fastening loosening off. The washer's effectiveness depends on the design conditions of the particular case and […]
2007
English
STEEL SELF-DRILLING TAPPING SCREWS
1.1 Scope. This inch series standard covers requirements for steel, self-drilling, tapping screws suitable for use in general engineering applications. The objective of this standard is to ensure that self-drilling tapping screws, by meeting the mechanical and performance requirements sp […]
1999
English
PIN, STRAIGHT, HEADLESS (DOWEL) (.0002 OVER NOMINAL SIZE)
CARBON OR ALLOY STEEL PINS SHALL HAVE A CORE HARDNESS OF 47-58 HRC, AND A CASE HARDNESS OF 60 HRC MINIMUM. THE CORE HARDNESS OF THE PINS SHALL NOT IN ANY INSTANCE EXCEED THE CASE HARDNESS. MINIMUM PENETRATION FOR THE CASE HARDNESS SHALL NOT BE LESS THAN .020 INCH. PINS 1/16 INCH AND LESS […]
1981
English
Retaining rings with lugs for use on shafts (external circlips)
For the purpose of this standard, retaining rings with lugs are circlips for use on shafts. They have an eccentric form and a number of lugs of equal depth uniformly distributed around the circumference. Circlips are suitable for retaining machine components which have non-square (radiuse […]
1992
English
Hexagon thin nuts with metric fine pitch thread – Product grades A and B (ISO 8675 :1988) English version of DIN EN 28675
This International Standard gives specifications for hexagon thin nuts, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade A for sizes d up to and including 16 mm and product grade B for sizes d over 16 mm.
2001
English
Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method
This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws and studs; — thread rolling screws; — self-tapping screws; — self-drilling screws; — nuts; — wash […]