ISO 1478

Tapping screws thread

English 1983
0.000
ISO
Detailed Information

This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 965-3
1980
English

ISO general purpose metric screw threads – Tolerances – Part 3 : Deviations for constructional threads

This International Standard specifies deviations for pitch and crest diameters for ISO general purpose metric screw threads conforming to ISO 261, ISO general purpose metric screw threads - Gen [...]
DIN
DIN 6887
1968
English

Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application

So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must [...]
DIN
DIN 917
2000
English

Hexagon cap nuts

This standard specifies dimensions and technical delivery conditions for sizes M4 to M72 coarse and fine pitch thread hexagon cap nuts of product grade A.
ISO
ISO 8992
1986
English

Fasteners — General requirements for bolts, screws, studs and nuts

This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requiremen [...]
DIN
DIN 6880
1975
English

Bright steel for key bars – Dimensions, limit deviations, mass

This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Se [...]
DIN
DIN 1151
1973
English

Round plain head and countersunk head wire nails

Wire nails shall be made of steel (grade at manufacturer's discretion) and have a bright (bk), galvanized (zn) or metallized (me) finish.
DIN
DIN 431
2000
English

Pipe nuts with thread as in ISO 228-1

This standard specifies dimensions and technical delivery conditions for sizes G 1/8 to G 6 (hexagon and octagon) pipe nuts with thread as in ISO 228-1 and of product grades B and C.
ASTM
Abstract of ASTM F835M
1992
English

ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS [METRIC]

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws M3 through M20 thread sizes havin [...]
DIN
DIN 2095
1973
English

Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs

This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compress [...]