ISO 225

Fasteners – Bolts, screws, studs and nuts – Symbols and designations of dimensions

English French Russian 1983
0.000
ISO
Detailed Information

This International Standard lays down the method of dimensioning bolts, screws, studs and nuts, recommended for use unless otherwise specified in the appropriate product Standards.

It includes common symbols and describes the feature.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 7168
1991
English

General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)

This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted correctly, and also to inform the user of this standard that, for all new designs, tolerances are to […]
ISO
ISO 225
1983
English, French, Russian

Fasteners – Bolts, screws, studs and nuts – Symbols and designations of dimensions

This International Standard lays down the method of dimensioning bolts, screws, studs and nuts, recommended for use unless otherwise specified in the appropriate product Standards. It includes common symbols and describes the feature.
DIN
DIN 605
1981
English

Flat countersunk square neck bolts with long square

This standard specifies flat countersunk square neck bolts with long square, with metric threads M 6, M 8 and M 10, of product grade C.
IFI
IFI-110
2008
English

GLOSSARY OF TERMS RELATING TO BLIND RIVETS

This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivet […]
DIN
DIN 608
1981
English

Flat countersunk square neck bolts with short square

This standard specifies flat countersunk square neck bolt with short square, with metric threads M 10 and M 12, of product grade C.
ASTM
Abstract of ASTM F812/F812M
2002
English

SURFACE DISCONTINUITIES OF NUTS

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of nuts with nominal diameters 1/4 in. and larger.