ISO 2768-1

General tolerances — Part 1 : Tolerances for linear and angular dimensions without individual tolerance indications

English 1989
0.000
ISO
Detailed Information

This part of ISO 2768 is intended to simplify drawing indications and it specifies general tolerances for linear and angular dimensions without individual tolerance indications in four tolerance classes.

Download File
(Log in to download spec.)

Check out other specifications

ASME
ASME B18.2.8
1999
English

CLEARANCE HOLES FOR BOLTS, SCREWS, AND STUDS

This standard covers the recommended clearance hole sizes for #0 through 1.5 inch fasteners in three classes of clearance using a close-, normal-, and loose-fit category.
Others
NF E 25-511
1984
French

RONDELLES CONIQUES STRIÉES DE SERRAGE Symbole CS

La présente norme fixe les caractéristiques des rondelles coniques striées de serrage en acier au carbone, et définit les essais à effectuer pour leur contrôle. Elles sont généralement utilisées avec des vis à métaux de grade A ou B, de diamètre 3 à 20 mm, de classes de qualité 6.8 et 8 […]
JIS
JIS B 0209-5
2001
English

ISO general purpose metric screw threads — Tolerances — Part 5: Limits of sizes for internal screw threads to mate with hot-dip galvanized external screw threads with maximum size of tolerance position h before galvanizing

This Standard specifies deviations and limits of sizes for pitch and crest diameters for ISO general purpose metric internal screw threads conforming to JIS B 0205-3 having basic profile according to JIS B 0205-1. Internal screw threads according to this Standard are intended to mate wit […]
ASTM
Abstract of ASTM A563
2000
English

CARBON AND ALLOY STEEL NUTS

This specification covers chemical and mechanical requirements for eight grades of carbon and alloy steel nuts for general structural and mechanical uses on bolts. studs. and other externally threaded parts.
ISO
ISO 14584
2001
English

Hexalobular socket raised countersunk head screws

This International Standard specifies the characteristics of hexalobular socket raised countersunk head screws in product grades A and with thread sizes from M2 to M10 inclusive.
IFI
IFI-166
2007
English

INSPECTION PROCEDUR FOR THREAD NICKS – INCH SERIES

This standard establishes an inspection procedure to determine acceptability of thread nicks as they relate to screw thread assemblability. This procedure is intended to be used for bolts, screws and studs of carbon or alloy steel #10 thru 1~ inch in diameter. This procedure applies to Un […]