ISO 2903

ISO metric trapezoidal screw threads – Tolerances

English 1977
0.000
ISO
Detailed Information

This International Standard specifies a tolerance system for metric trapezoidal screw threads according to ISO 2902. The tolerances refer to the basic profile according to ISO 2901.

The tolerance system does not apply to trapezoidal screw threads with special requirements on axial displacement, for example lead screws.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes [...]
DIN
DIN 74361-3
1979
English

Disc wheels for motor vehicles and trailers – Dimensions and fasteners for attachment with centring on wheel bore

This standard specifies requirements for the attachment of disc wheels with 15° tapered rims as covered in DIN 78 022, on commercial vehicles and trailers. Design-related details left unspecif [...]
ISO
ISO 1207
1992
English

Slotted cheese head screws – Product grade A

This International Standard specifies the characteristics of slotted cheese head screws of product grade A and with threads from M1,6 to M10 inclusive. If, in special cases, specifications oth [...]
ASTM
Abstract of ASTM A194/A194M
2010
English

CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the [...]
BS EN ISO
BS EN ISO 286-2
2010
English

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers val [...]
DIN
DIN 6884
1956
English

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]
ASME
ASME B18.2.3.9M
1999
English

METRIC HEAVY HEX FLANGE SCREWS

This standard covers the complete dimensional and general data for metric series heavy hex flange screws recognized as American National Standard.
DIN
DIN 1816
1971
English

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Part 4
DIN
DIN 267-10
1988
English

Fasteners – Technical delivery conditions – Hot-dip galvanized parts

Th s standard specifies the technical delivery conditions for fasteners (mainly screws. bolts and nuts) with an M 6 to M 36 coarse thread and provided with a zinc coating applied by hot-dip gal [...]