ISO 5864
ISO inch screw threads – Allowances and tolerances
English
1978
0.000
Detailed Information
This International Standard specifies a system of allowances and tolerances for standard thread series, covering the range of diameters from 0.06 to 6 in, and pitches from 80 to 4 threads per inch.
Download File
(Log in to download spec.)
Check out other specifications
2008
English
FINISH SPECIFICATION
The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineer […]
1998
English
SETSCREW-HEXAGON SOCKET, CUP POINT, CORROSION-RESISTING STEEL, PASSIVATED, UNC-3A, PLAIN AND SELF-LOCKING
SELF-LOCKING ELEMENT: (a) THE SELF-LOCKING ELEMENT SHALL BE IN ACCORDANCE WITH MIL-F-18240. (b) FOR DESIGN AND USAGE LIMITATIONS, SEE MS15981. (c) LOCATION OF EFFECTIVE LOCKING AREA SHALL BE IN ACCORDANCE WITH MS15981. (d) MAXIMUM RING GAGE DIAMETER THAT LOCKING REGION OF SETSCREW MUST PA […]
2008
English
STRUCTURAL SPLITTING SELF-PLUGGING PULL MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical and performance requirements for structural splitting self-plugging pull mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.
2006
English
High-strength structural bolting assemblies for preloading – Part 6: Plain chamfered washers (includes Corrigendum AC:2006) English version of DIN EN 14399-6:2006-06
This document specifies, together with EN 14399-1, hardened and tempered plain washers with chamfer intended for assembly with large series hexagon high-strength structural bolts and nuts with thread sizes from M12 to M36 inclusive.
1981
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Teile aus Nichteisenmetallen
Diese Norm gilt für mechanische Verbindungselemente mit Gewinde (im wesentlichen Schrauben und Muttern) als Fertigteile aus Nichteisenmetallen (Schwermetalle und Leichtmetalle) mit - metrischem ISO-Gewinde nach DIN 13, - Blechschraubengewinde nach DIN 7970, - Holzschraubengewinde nach DIN […]
2004
English
Metallic products – Types of inspection documents
1.1 This document specified the different types of inspection documents supplied to the purchaser, in accordance with the requirements of the order, for the delivery of all metallic products e.g. plates, sheets, bars, forgings, castings, whatever their method of production. 1.2 This docum […]