ISO 7050

Cross recessed countersunk (flat) head tapping screws (common head style)

English 1983

0.000

Detailed Information

This International Standard specifies the characteristics of cross recessed countersunk (flat) head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.

Download File

(Log in to download spec.)

Check out other specifications

ASME

ASME B18.2.9

2010

English

STRAIGHTNESS GAGE AND GAGING FOR BOLTS AND SCREWS

1 SCOPE This Standard describes a gage and procedure for checking bolt or screw straightness at maximum material condition (MMC) and provides default limits when not stated in the applicable product standard. 2 COMPARISON WITH ISO 4759-1:2000 This Standard uses an adjustable gage, instea […]

ASTM

Abstract of ASTM F835

2000

English

ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) 0.060 through 0.625 in. thread sizes and flat countersunk (SFHCS) 0.060 through 1.5 in. thread sizes head cap screws having material properties for high strength requirements.

NASM

NASM 51959

1999

English

SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 82°, CROSS-RECESSED, CORROSION-RESISTANT STEEL, UNC-2A

MATERIAL: AUSTENITIC CORROSION-RESISTANT STEEL SCREWS SHALL BE MANUFACTURED FROM TYPE 302 (UNS S30200), TYPE 304 (UNS S30400). TYPE 304L (UNS S30403). TYPE 305 (UNS S30500), TYPE 316 (UNS 531600), TYPE 316L (UNS 531603). TYPE 384 (UNS S38400), OR TYPE XM-7 (UNS S30430) IN ACCORDANCE WITH […]

ISO

ISO 7378

1983

English

Fasteners – Bolts, screws and studs – Split pin holes and wire holes

This International Standard lays down the dimensions and position of split pin holes and wire holes for bolts, screws and studs, recommended for use unless otherwise specified in the appropriate product standard.

DIN

DIN 59370

1978

English

Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights

This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.

IFI

IFI-520

1999

English

METRIC PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.