ISO 7414

Hexagon nuts for structural bolting with large width across flats. style 1 – Product grade B – Property class 10

English 1984
0.000
ISO
Detailed Information

This International Standard gives specifications for large series hexagon nuts, style 1, property class 10, with metric dimensions and thread sizes from M12 up to and including M36, for use with bolts of property class 10.9.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 929
2000
English

Hexagon weld nuts

This standard specifies requirements for sizes M3 to M16 coarse and fine pitch thread hexagon weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN EN ISO 898-1. Hexagon weld nuts with flange are specified in DIN 977.
DIN
DIN 6902
1990
English

Plain washers for screw and washer assemblies

Washers as specified in this standard are intended for use with screw and washer assemblies as specified in DIN 6900 Parts 1 to 3.
JIS
JIS B 1082
1987
English

Stress area and bearing area for threaded fasteners

This Japanese Industrial Standard specifies the stress area of metric screw thread and the area of the part where a load due to the contact of the bearing surface of threaded fastener and the other side is added, hereinafter referred to as the ”load area”. Furthermore, the method to obta […]
DIN
DIN 6886
1967
English

Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application

For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the […]
BS EN ISO
BS EN ISO 286-2
2010
English

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit devia […]
ASTM
Abstract of ASTM F959M
1997
English

COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are c […]