ISO 8015

Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules

English 2011
0.000
ISO
Detailed Information

This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) and verification.

This International Standard applies to the interpretation of GPS indications on all types of drawings.

For the purposes of this International Standard, the term “drawing” is to be interpreted in the broadest possible
sense, encompassing the total package of documentation specifying the workpiece.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 1015
2001
English

Hexalobular internal driving feature for bolts and screws

This Standard specifies the shape and basic dimensions of hexalobular internal driving feature for bolts and screws including the gauging method. The curvature of the contour of the hexalobula [...]
ISO
ISO 3800-1
1977
English

Threaded fasteners – Axial load fatigue testing – Part 1 : Test methods

This International Standard specifies the conditions for carrying out axial load fatigue tests on threaded fasteners.
ISO
ISO 7093
1983
English

Plain washers – Large series – Product grades A and C

This International Standard lays down the specification for plain washers of product grades A and C with outside diameter three times nominal size (nominal thread diameter), preferable for hexa [...]
DIN
DIN 267-1
1982
English

Fasteners – Technical delivery conditions – General requirements

This standard applies to standardized fasteners (mainly bolts, screws, nuts and similar threaded and formed parts) as finished components in the condition on delivery, in so far as no special s [...]
ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes [...]
DIN
DIN 316
1983
English

Wing screws

In June 1975, drafts of the planned new editions of DIN 315 (wing nuts) and of DIN 316 (wing screws) were published; they made a distinction between Part 1 "heavy duty type" and Part 2 "light d [...]
DIN EN
DIN EN 26157-1
1991
English

Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)

1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nomi [...]
IFI
IFI-123
2008
English

DRIVE PIN BLIND RIVETS

This standard establishes the requirements for drive pin blind rivets suitable for use in joining the component parts of an assembly.
DIN
DIN 6905
1990
English

Spring lock washers for screw and washer assemblies

Spring lock washers as specified in this standard are intended for use with screw and washer assemblies as specified in DIN 6900 Part 3. They are designed for use with bolted connections with b [...]