ISO 8734

Parallel pins of hardened steel and martensitic stainless steel (Dowel pins)

English 1997
0.000
ISO
Detailed Information

This International Standard specifies the characteristics of parallel pins (dowel pins) of steel, through hardened or case hardened and martensitic stainless steel with nominal diameters, d, from 1 mm to 20 mm inclusive.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 8677
1986
English

Cup head square neck bolts with large head – Product grade C

This International Standard specifies the characteristics of cup head square neck bolts with large head, with metric dimensions and thread sizes from M5 to M20 inclusive, of product grade C.
JIS
JIS B 1006
1985
English

Thread run-outs and thread undercuts for external threaded fasteners

This Japanese Industrial Standard specifies the length of thread run-outs and the form and dimensions of thread undercut shanks applied to the threaded portion of generally used fasteners with [...]
ISO
ISO 7093
1983
English

Plain washers – Large series – Product grades A and C

This International Standard lays down the specification for plain washers of product grades A and C with outside diameter three times nominal size (nominal thread diameter), preferable for hexa [...]
DIN
DIN 261
1987
English

T-head bolts

This standard specifies M8 to M100 x 6 T-head bolts. They are designed for use in attaching components to foundations or similar structures by means of T-sIots, such as are specified in DIN 649 [...]
DIN
DIN 940
1995
English

Studs – with a length of engagement equal to about 2,5 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in light metals of low strength. As specified in DIN 267-2, the stud end thread shall be p [...]
IFI
IFI-100/107
2007
English

PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS REGULAR AND LIGHT HEX SERIES

This standard establishes the dimensional, mechanical and performance requirements for three grades of prevailing-torque type steel hex nuts, in sizes No.4 thru 1-1/2 in., and two grades of pre [...]
ASME
ASME B18.2.3.4M
1999
English

METRIC HEX FLANGE SCREWS

1.1 This standard covers the complete dimensional and general data for metric series hex flange screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this st [...]
DIN
DIN 268
1974
German

Tangentkeile und Tangentkeilnuten für stoßartige Wechselbeanspruchungen

Die vorliegende Norm entspricht sachlich dem ISO-Entwurf ISO/DIS 3117 -1973 Tangential keying Clavetage par clavettes tangentielles Tangentkeile und Tangentkeilnuten Dieser ISO-Entwurf enthält [...]
IFI
IFI-135
2008
English

MECHANICAL TESTING OF BLIND RIVETS

1.1 Scope. This standard describes procedures for the mechanical testing of inch series blind rivets to determine properties required in the product standard. 1.2 The following tests are descri [...]