ISO 885

General purpose bolts and screws – Metric series – Radii under the head

English 1976
0.000
ISO
Detailed Information

This International Standard specifies the sizes of the radii under the head of metric series general purpose bolts and screws.

Download File
(Log in to download spec.)

Check out other specifications

DIN EN
DIN EN 10025
1994
English

Hot rolled unalloyed structural steel products – Technical delivery conditions (includes Amendment A 1 : 1993) English version of DIN EN 10025

1.1 This European Standard specifies requirements for long products and flat products of hot rolled non-alloy, base and quality steels in the grades and qualities given in tables 2 and 3 (chemi [...]
SAE
SAE J531
2020
English

Automotive Pipe, Filler, and Drain Plugs

This SAE Standard includes complete general and dimensional specifications for those types of pipe, filler, and drain plugs (shown in Figures 1 to 6 and Tables 1 to 4) commonly used in automoti [...]
ASTM
ASTM B16 B16M
2005
English

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for high- [...]
DIN
DIN 918
1979
English

Fasteners – Terminology – Spelling of terms – Abbreviations

This standard applies to fasteners as described in clause 2 and specifies terms for them, terms for the most important characteristics of the parts and their abbreviations. When specifying desc [...]
DIN
DIN 982
1987
English

Prevailing torque type hexagon nuts with nonmetallic insert

This standard specifies requirements for M 5 to M 24 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A for sizes up to M 16 and product grade B for sizes [...]
DIN
DIN 963
1970
English

Slotted Countersunk (Flat) Head Screws (Countersunk Heads according to ISO)

Intermediate length should as for as possible be avoided. Lengths over 100 mm should be arranged in 10 mm steps. Normally these screws are manufactured in the sizes characterized by the quoted [...]
DIN
DIN 7981
1984
English

Cross recessed pan head tapping screws

DIN 6901 shall apply for the designation of tapping screws with captive washer components (tapping screw assemblies). DIN 4000-2-1 tabular layout of article characteristics shall apply for scre [...]
DIN
DIN 835
1995
English

Studs with a length of engagement equal to about 2 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in aluminium alloys. As specified in DIN 267-2, the stud end thread shall be produced to t [...]
ISO
ISO 898-5
1980
English

Mechanical properties of fasteners – Part 5 : Set screws and similar threaded fasteners not under tensile stresses

This International Standard specifies the mechanical properties of set screws and similar fasteners not under tensile stresses in the range from 1,6 up to and including 39 mm thread diameter wh [...]