ISO 898-2

Mechanical properties of fasteners made of carbon steel and alloy steel — Part 2: Nuts with specified property classes — Coarse thread and fine pitch thread

English 2012
0.000
ISO
Detailed Information

This part of ISO 898 specifies mechanical and physical properties of nuts with coarse thread and fine pitch thread made of carbon steel and alloy steel when tested at an ambient temperature range of 10 °C to 35 °C. Nuts conforming to the requirements of this part of ISO 898 are evaluated at that ambient temperature range. It is possible that they do not retain the specified mechanical and physical properties at elevated and/or lower temperatures.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 404
1986
English

Slotted capstan screws

Slotted capstan screws may be used both as fastening and adjusting screws. They are primarily designed for use in electrical engineering and may be tightened by means of a sliding tee bar where [...]
DIN EN
DIN EN 1664
1998
English

Prevailing torque type all-metal hexagon nuts with flange (ISO 7044: 1997, modified) English version of DIN EN 1664

This European Standard specifies the characteristics of prevailing torque type all-metal hexagon nuts with flange and threads from M5 up to M20 inclusive, in product grade A for threads up to a [...]
DIN
DIN 76-1
2004
English

Thread run-outs and thread undercuts for ISO metric threads as in DIN 13-1

This standard specifies dimensions for thread run-outs and thread undercuts for bolts, screws and similar components with external or internal ISO metric (coarse or fine pitch) thread as in DIN [...]
DIN
DIN 258
1977
English

Taper Pins with Thread Ends and Constant Taper Lengths

As part of the work of Technical Committee ISO/TC 2, ISO standards for parallel pins and taper pins have been drawn up which necessitated a general revision of existing DIN standards. In that p [...]
DIN
DIN 914
1980
English

Hexagon socket set screws with cone point – ISO 4027 modified

ISO 4027 specifies product grade A hexagon socket set screws with cone points with metric dimension and thread diameters from 1,6 up to and including 24 mm.
DIN
DIN 9021
1990
English

Large size washers

This standard specifies requirements for product grades A and C washers with a large outside diameter, i.e. washers with an outside diameter approximately equal to three times the nominal threa [...]
ISO
ISO 2904
1977
English

ISO metric trapezoidal screw threads – Basic dimensions

This International Standard specifies the basic dimensions for ISO metric trapezoidal screw threads according to ISO 2902. The values refer to the basic profiles according to ISO 2901.
ISO
ISO 2903
1977
English

ISO metric trapezoidal screw threads – Tolerances

This International Standard specifies a tolerance system for metric trapezoidal screw threads according to ISO 2902. The tolerances refer to the basic profile according to ISO 2901. The tolera [...]
ISO
ISO 7047
1983
English

Cross recessed raised countersunk head screws (common head style) – Product grade A

This International Standard specifies the characteristics of cross recessed raised countersunk head screws with thread sizes from M 1,6 to M 10 inclusive. If other specifications are required, [...]