JIS B 0123

Designation system for screw threads

English 1999
0.000
JIS
Detailed Information

This Japanese Industrial Standard specifies designation for screw threads used in the Standards referring the principle of screw thread and the Standards referring the products having screw thread.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 1045
2001
English

Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method

This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws a [...]
DIN
DIN 267-12
1971
English

Bolts, Screws, Nuts and Similar Threaded and Formed Parts – Technical Conditions of Delivery – Self-Tapping Screws

The provisions of this Standard supplement DIN 267 Part 1, Part 2, Part 5, Part 7 and Part 9 and apply to self-tapping screws made of heat-treated steel except when there are compelling reasons [...]
DIN
DIN 267-4
1983
English

Fasteners – Technical delivery conditions – Property classes for nuts (previous classes)

DIN 267 Part 4 was converted to the international property classes for nuts in 1967. The previous symbols 4D, 5D, 5S, 6G, 6S and 8G were replaced by code numbers 4, 5, 6, 8, 10, 12 and 14 where [...]
DIN
DIN 1816
1971
English

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Part 4
JIS
JIS B 1054-2
2001
English

Mechanical properties of corrosion-resistant stainless-steel fasteners — Part 2 : Nuts

This part of JIS B 1054 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic grades of corrosion- resistant stainless steels when tested over an ambient temp [...]
ISO
ISO/R 2101
1971
English

ALUMINIUM AND ALUMINIUM ALLOYS – SHEAR TEST FOR RIVET WIRE AND RIVETS

This ISO Recommendation applies to the shear testing of aluminium and aluminium alloy rivet wire and rivets, having a diameter not greater than 10 mm (3/8 in).