JIS B 0147
Blind rivets—Terminology and definitions
English
2004
0.000
Detailed Information
This Standard specifies the terminology and definitions for types, performance characteristics and geometry for blind rivets and the terminology for blind rivet setting and setting equipment used generally in blind riveting.
Download File
(Log in to download spec.)
Check out other specifications
1997
English
Standard Specification for Style 1 Stainless Steel Metric Nuts
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric nuts with nominal thread diameters M1.6 through M36, and intended for use in engineering applications requiring general corrosion resistance. 1.2 Eight groups of stainless steel alloys are co […]
1995
English
Studs – with a length of engagement equal to about 1,25 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in cast iron. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.
1994
English
SURFACE DISCONTINUITIES ON BOLTS, SCREWS, AND STUDS IN FATIGUE APPLICATIONS
This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur or become apparent during the manufacture and processing of bolts, screws, and studs which are primarily intended for use in automotive assemblies […]
1997
English
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use [Metric]
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws. and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specifie […]
1993
English
Standard Specification for High-Strength Nonheaded Steel Bolts and Studs
1.1 This specification covers the chemical and mechanical requirements for quenched and tempered steel nonheaded bolts and studs with enhanced Charpy V-notch impact properties for anchorage and other purposes. The material shall be alloy steel as described in Table 1 and is limited to 5/8 […]
2009
English
Continuously hot-dip coated steel flat products – Technical delivery conditions – English version of DIN EN 10346:2009-07
This European Standard specifies requirements for continuously hot-dip coated products made of low carbon steels for cold forming, of steels for construction, of steels with high proof strength for cold forming and coated with zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), alu […]