Check out other specifications
1997
English
Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of metric-series nuts with nominal diam [...]
2004
English
Standard Specification for Steel Bars, Alloy, Hot-Wrought or Cold-Finished, Quenched and Tempered
1.1 This specification covers hot-wrought and cold-finished quenched and tempered alloy steel bars. 1.2 Hot-wrought bars are available in three strength level classes designated BB, BC, and BD, [...]
1983
English, French, Russian
Fasteners – Bolts, screws, studs and nuts – Symbols and designations of dimensions
This International Standard lays down the method of dimensioning bolts, screws, studs and nuts, recommended for use unless otherwise specified in the appropriate product Standards. It includes [...]
1991
English
Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)
1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nomi [...]
1984
English
Thread rolling screws for ISO metric thread – Guideline values for hole diameters
This standard specifies hole diameters for thread rolling screws conforming to DIN 7500 Part 1. These hole diameters are the result of tests carried out by manufacturers and users. The values g [...]
1999
English
Tolerances for fasteners— Part 3 : Plain washers for bolts, screws and nuts—Product grades A and C
This Japanese Industrial Standard specifies a selection of tolerances for use in the preparation of the product standards for plain washers, grades A and C, for bolts, screws and nuts with nomi [...]