JIS B 0210

Limits of sizes and tolerances for unified coarse screw threads

English 1973
0.000
JIS
Detailed Information

This Japanese Industrial Standard specifies limits of sizes and tolerances for unified coarse screw threads specified in JIS B 0206-Unified Coarse Screw Threads, mainly used for the purpose of fastening .

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 6887
1968
English

Stressed-type Fastenings with Taper Action – Taper Keys with Gib Head – Keyways – Dimensions and Application

So far no permissible variations have been laid down for the taper on the key and in the keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h1 is the maximum height of the key (less gib […]
JIS
JIS B 1051
2000
English

Mechanical properties of fasteners made of carbon steel and alloy steel— Part 1 : Bolts, screws and studs

This Standard specifies the mechanical properties of bolts, screws and studs made of carbon steel and alloy steel when tested at an ambient temperature range of 10 °C to 35 °C. Products conforming to the requirements of this Standard are evaluated only in the ambient temperature range an […]
ISO
ISO 887
1983
English

Plain washers for metric bolts, screws and nuts – General plan

This International Standard lays down the specification for the full range of plain washers of product grades A and C for bolts, screws and nuts with thread sizes from M 1 to M 150 inclusive. This International Standard does not apply to washers for preassembled bolts and screws as far a […]
DIN
DIN 86102
1965
English

Screwed Ends, Tapped Holes for Pipe Unions, Armatures and Plugs with Whitworth Pipe Thread – Design Sheet for Shipbuilding

This Standard contains a selection from DIN 3852 Sheet 2 for the shipbuilding industry with some diverging or complementary data.
DIN
DIN 564
1995
English

Hexagon set screws with small hexagon, half dog point and flat cone point

This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M36 hexagon set screws with small hexagon, half dog point and flat cone point, assigned to product grade A. These screws are only to be used as forcing screws (i e. for adjusting an […]
DIN
DIN 961
1990
English

M8 x 1 to M52 x 3 hexagon head bolts with fine pitch thread – Product grades A and B

This standard specifies requirements for M8 to M52 hexagon head bolts threaded up to the head. with metric fine pitch thread, assigned to product grade A for sizes up to M24 and lengths not exceeding 10 d or 150 mm, whichever is shorter, and product grade B for sizes larger than M24 or le […]