JIS B 1013

Countersunk head screws— Head configuration and gauging

English 1994
0.000
JIS
Detailed Information

This Standard specifies the characteristics of head configurations of slotted and recessed countersunk head screws, and recommends a gauging method for the head dimensions laid down in the respective product standards.

Download File
(Log in to download spec.)

Check out other specifications

IFI
IFI-117
2008
English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load trans [...]
JIS
JIS B 1124
2003
English

Drilling screws with tapping screw thread

This Standard is the Japanese Industrial Standard prepared based on first editions of ISO 15480 Hexagon washer head drilling screws with tapping screw thread, ISO 15481 Cross recessed pan head [...]
JIS
JIS B 0225
1960
English

Cycle threads

This standard covers the threads to be used for bicycle, rear cart and the other similars.
DIN
DIN 553
1986
English

Slotted set screws with cone point (modified version of ISO 7434, 1983 edition )

This standard specifies the characteristics of M 1 to M 12 slotted set screws with cone point, assigned to product grade A. Where, for special purposes, the screws are to meet requirements diff [...]
NASM
NASM 35307
1999
English

SCREW, CAP, HEXAGON HEAD (FINISHED HEXAGON BOLT), STEEL, CORROSION RESISTING, PASSIVATED, UNC-2A

MECHANICAL PROPERTIES: The minimum tensile strength in load pounds, indicated in Table I is based on 80,000 PSI Minimum Tensile Strength for diameters through .625 inch and 70,000 PSI Minimum T [...]
ASTM
Abstract of ASTM F959M
1997
English

COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural b [...]
ISO
ISO 6506-1
2014
English

Metallic materials — Brinell hardness test — Part 1: Test method

This part of ISO 6506 specifies the method for the Brinell hardness test for metallic materials. It is applicable to both fixed location and portable hardness testing machines. For some specif [...]
ASTM
Abstract of ASTM A307
2000
English

CARBON STEEL EXTERNALLY THREADED STANDARD FASTENERS

1.1 This specification covers the chemical and mechanical requirements of three grades of carbon steel bolts and studs, in sizes 1/4 in. through 4 in. The fasteners are designated by "Grade" de [...]
ASTM
ASTM F959
2009
English

COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural b [...]