JIS B 1021

Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C

English 2003

0.000

Detailed Information

This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.

Download File

(Log in to download spec.)

Check out other specifications

DIN EN

DIN EN 1663

1998

English

Prevailing torque type hexagon nuts with flange (with non-metallic insert) (ISO 7043 : 1997, modified) English version of DIN EN 1663

This European Standard specifies the characteristics of prevailing torque type hexagon nuts with flange, with non-metallic annular insert and coarse threads from M5 to M20 inclusive, in product grade A for threads up to and including M16 and product grade B for threads above M16 and with […]

DIN

DIN 137

1994

English

Wave spring washers

Spring lock washers as covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of a property class less than 5.8, as specified in DIN EN 20898 Part 1. They are Intended to counteract the effect of setting which results in bolt […]

ASTM

ASTM F468M

1997

English

Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use [Metric]

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws. and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specifie […]

SAE

SAE J123

1994

English

SURFACE DISCONTINUITIES ON BOLTS, SCREWS, AND STUDS IN FATIGUE APPLICATIONS

This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur or become apparent during the manufacture and processing of bolts, screws, and studs which are primarily intended for use in automotive assemblies […]

DIN EN

DIN EN 20898-6

1992

English

Mechanical properties of fasteners – Nuts with specified proof load values – Fine pitch thread (ISO 898-6 : 1988) English version of DIN EN 20 898 Part 6

This part of ISO 898 specifies the mechanical properties of nuts with specified proof load values: - with nominal thread diameters, d, from 8 mm up to and including 39 mm; - of triangular ISO thread and with diameters and pitches according to ISO 68 and ISO 262 (fine pitch thread); - with […]

IFI

IFI-110

2008

English

GLOSSARY OF TERMS RELATING TO BLIND RIVETS

This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivet […]