Check out other specifications
1999
English
METRIC BEVELED WASHERS
This standard covers metric steel beveled washers, in nominal sizes 12 thru 36 mm, intended for use with American Standard beams and channels in structural applications to compensate for the lack of parallelism where an outer face of the members to be joined has a slope approximately 1:6 […]
1963
English
Telecommunications Engineering – Contact Rivets – Soldered or Welded – Technical Conditions of Delivery
These conditions of delivery apply to contact rivets according to DIN 46240 Sheet 2 with soldered-on or welded-on tip (at manufacturer's option) in contact materials which are not capable of being shaped by nonoutting methods, e.g. tungsten. Subject to agreement between manufacturer and u […]
1999
English
Steel and nickel alloys for fasteners with specified elevated and/or low temperature properties – English version of DIN EN 10269
This European Standard specifies requirements for semi-finished products, bars and rods for fasteners with properties specified at elevated and/or low temperature made of non-alloy and alloy (including stainless) steels and nickel alloys as given in table 1. The general technical deliver […]
2003
English
General purpose bolts and screws — Metric series — Radii under the head
This Standard specifies the sizes of the radii under the head and the transition diameters of metric series general purpose bolts and screws.
1994
English
Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2
This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower temperature.
1995
English
UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)
This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0.600 to 6.000 in., and specifies limiting dimensions and tolerances. It specifies the characteri […]