JIS B 1054-2

Mechanical properties of corrosion-resistant stainless-steel fasteners — Part 2 : Nuts

English 2001
0.000
JIS
Detailed Information

This part of JIS B 1054 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic grades of corrosion- resistant stainless steels when tested over an ambient temperature range of 15 °C to 25 °C. Properties will vary at higher or lower temperatures.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 4753
2011
English

Fasteners – Ends of parts with external ISO metric thread

This International Standard specifies the form and dimensions of ends of parts with external ISO metric screw thread (e.g. bolt, screw and stud ends) recommended for use. They apply to standard [...]
Custom
John Deere | JDM F15
2014
English

Specification for Electroplated Zinc Coatings on Fasteners

JDM F15 specifies requirements for electroplated zinc coatings for fasteners made of steel. JDM F15 applies primarily to electroplated coatings on threaded fasteners, non-threaded fasteners, an [...]
ASTM
ASTM A394
1993
English

Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare

1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters [...]
DIN
DIN 6901
1990
English

Tapping screw and washer assemblies

This standard specifies requirements for screw and washer assemblies consisting of a tapping screw with f!at bearing face and a DIN 6903 captive washer
DIN
DIN 611
1990
English

Overview of standards for rolling bearings

This standard provides an overview of DIN Standards dealing with rolling bearings and related International Standards.
ISO
ISO 898-5
1980
English

Mechanical properties of fasteners – Part 5 : Set screws and similar threaded fasteners not under tensile stresses

This International Standard specifies the mechanical properties of set screws and similar fasteners not under tensile stresses in the range from 1,6 up to and including 39 mm thread diameter wh [...]
SAE
SAE J531
2020
English

Automotive Pipe, Filler, and Drain Plugs

This SAE Standard includes complete general and dimensional specifications for those types of pipe, filler, and drain plugs (shown in Figures 1 to 6 and Tables 1 to 4) commonly used in automoti [...]
JIS
JIS B 1128
2004
English

Hexalobular socket head tapping screws

This Standard specifies the characteristics of hexalobular socket head tapping screws with nominal thread size from ST2.9 to ST6.3. If specifications other than those listed in this Standard ar [...]
5.01
JIS
JIS B 1127
1995
English

Hexagon flange head tapping screws

This Standard specifies hexagon flange head tapping screws with threads from ST2.2 up to and including ST9.5.