JIS B 1086

Widening test on nuts

English 1998
0.000
JIS
Detailed Information

This Standard specifies the test procedure for evaluating the acceptability of surface discontinuities designated in JIS B 1042 excluding nuts made of free cutting steel.

It applies to nuts with
— nominal thread diameter, d, from 5 mm up to and including 39 mm;
— product grades A and B;
— property classes described in Annex 1 and Annex 2 to JIS B 1052.

Download File
(Log in to download spec.)

Check out other specifications

ASME
ASME B18.2.6
2011
English

FASTENERS FOR USE IN STRUCTURAL APPLICATIONS

1.1.1 This Standard covers the complete general and dimensional data for five products in the inch series recognized as an American National Standard. These five structural products include: a. [...]
DIN
DIN 271
1974
English

Tangential keys and Tangential Keyways for Constant Loads

The present Standard corresponds in subatanct to the ISO Draft lSO/DIS 3117-1973 Tagential keying Clavetage par clavettes tangentielles As compared with the April 1924 lssue of DIN 271, the fol [...]
JIS
JIS B 1043
1993
English

Fasteners—Surface discontinuities— Part 3 : Bolts, screws and studs for special requirements

This Standard establishes limits for various types of surface discontinuities on bolts, screws and studs for special requirements. It applies to bolts, screws and studs with — nominal thread [...]
ASTM
ASTM A394
2008
English

STEEL TRANSMISSION TOWER BOLTS, ZINC-COATED AND BARE

1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters [...]
ASTM
ASTM A380/A380M
2013
English

Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems

This practice covers recommendations and precautions for cleaning, descaling, and passivating of new stainless steel parts, assemblies, equipment, and installed systems. These recommendations a [...]
ASME ANSI
ASME/ANSI B18.3.6M
1993
English

METRIC SOCKET SET SCREWS

1.1.1 This standard contains complete general and dimensional requirements for metric series socket set screws of nominal sizes from 1.6 mm to 24 mm recognized as American National Standard. Al [...]
DIN
DIN 979
1987
English

Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B

This standard specifies requirements for M6 to M52 hexagon slotted nuts and castle nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). If, in special c [...]
DIN
DIN 7168
1991
English

General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)

This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted corre [...]
DIN
DIN 1151
1973
English

Round plain head and countersunk head wire nails

Wire nails shall be made of steel (grade at manufacturer's discretion) and have a bright (bk), galvanized (zn) or metallized (me) finish.