JIS B 1099

Fasteners — General requirements for bolts, screws, studs and nuts

English 2005
0.000
JIS
Detailed Information

This Standard specifies the general requirements for standardized bolts, screws, studs and nuts. It refers to the Standards on tolerances, mechanical and performance characteristics, geometrical features, surface discontinuities, surface finishes and quality aspects.

Download File
(Log in to download spec.)

Check out other specifications

SAE
SAE J2044
2009
English

Quick Connect Coupling Specification for Liquid Fuel and Vapor/Emissions Systems

This SAE Recommended Practice defines the minimum functional requirements for quick connect couplings used for supply, return, and vapor/emission fuel system connections. This document also def [...]
DIN EN
DIN EN 28673
1992
English

Hexagon nuts, style 1, with metric fine pitch thread – Product grades A and B (ISO 8673 : 1988) English version of DIN EN 28 673

This International Standard gives specifications for hexagon nuts, style 1, with metric fine pitch thread with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade [...]
DIN
DIN 6880
1975
English

Bright steel for key bars – Dimensions, limit deviations, mass

This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Se [...]
ISO
ISO 8765
1988
English

Hexagon head bolts with metric fine pitch thread – Product grades A and B

This International Standard gives specifications for hexagon head bolts with metric fine pitch thread with nominal thread diameters d from 8 to 64 mm of product grade A for nominal thread diame [...]
ANSI
ANSI B18.16.2M IFI Comment
1995
English

TORQUE-TENSION TEST REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL METRIC HEX NUTS AND HEX FLANGE NUTS

Unfortunately, the values needed to complete this standard are not yet agreed to. ISO standard 2320 provides values which make no distinction between normal and low friction and are not accepte [...]
ASME
ABSTRACT OF ASME B1.2
2007
English

GAGES AND GAGING FOR UNIFIED INCH SCREW THREADS

This standard provides essential specifications and dimensions for the gages used on Unified inch screw threads (UN and UNR thread form), and covers the specifications and dimensions for the th [...]
DIN
DIN 798
1972
English

Special Foundation Nuts for Special Foundation Bolts according to DIN 797

Strength category or material: 5 according to DIN 267 Sheet 4 Other strength categories or materials by spociel agreement.
NASM
NASM 35338
2002
English

WASHER, LOCK-SPRING, HELICAL, REGULAR (MEDIUM) SERIES

a. CARBON STEEL WASHERS SHALL HAVE A HARDNESS OF 38 TO 46HRC. b. CORROSION-RESISTANT STEEL WASHERS TYPE 420 (UNS S42000) SHALL HAVE A HARDNESS OF 45-53 HRC, AND TYPE 300 (UNS S3XXXX) SERIES WAS [...]
BS EN
BS EN 20898-2
1994
English

Mechanical properties of fasteners – Part 2: Nuts with specified proof load values – Coarse thread

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower te [...]