Check out other specifications
1986
English
Slotted set screws with full dog point
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April 1968 edition, has been replaced by product grade F as specified in DIN 267 Pa […]
1986
English
Round nuts with drilled holes in one face
Round nuts with drilled holes in one face are parts generally made of steel, stainless steel or non-ferrous metals, which are designed to be used for various purposes, as for instance in electrical engineering. They can be tightened by means of a pin type face wrench as specified m DIN 31 […]
1992
English
Plain washers for use with clevis pins, product grade A (ISO 8738 : 1986) English version of DIN EN 28 738
This International Standard specifies the characteristics of plain washers for clevis pins according to ISO 2340 and ISO 2341. Plain washers in accordance with this International Standard shall be used on the cotter pin end only.
1971
English
ALUMINIUM AND ALUMINIUM ALLOYS – SHEAR TEST FOR RIVET WIRE AND RIVETS
This ISO Recommendation applies to the shear testing of aluminium and aluminium alloy rivet wire and rivets, having a diameter not greater than 10 mm (3/8 in).
1993
English
TAPPING SCREW APPROXIMATE HOLE SIZES
The approximate hole sizes set forth on the following pages are intended to provide general guidance to the user in selecting holes for installing the respective types of thread forming and thread cutting tapping screws in various commonly used materials. It should be noted, however, that […]