JIS B 1136

Hexalobular socket head cap screws

English 2004
0.000
JIS
Detailed Information

This Standard specifies the characteristics of hexalobular socket head cap screws with thread sizes from M2 up to and including M20, of product grade A.

If, in special cases, specifications other than those listed in this International Standard are required, they should be selected from existing International Standards, e.g. JIS B 0205-2, JIS B 0209-2, JIS B 0209-3, JIS B 1009, JIS B 1021, JIS B 1051 and JIS B 1054-1.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 2999-2
1973
English

Whitworth Pipe Threads for Tubes and Fittings – Cylindrical Internal Thread and Conical External Thread – Gauging System and Use of Gauges

The gauging system takes account of the function of the screwed joints and of practical installation requirements. The cylindrical internal thread is therefore gauged with a conical screw limit plug gauge with a 1:16 taper. In this case the screw limit plug gauge represents the conical ex […]
ISO
ISO 273
1979
English

Fasteners — Clearance holes for bolts and screws

This International Standard specifies clearance hole diameters for general purpose applications. These values result from bearing area calculations in connection with ISO bolt and nut product standards.
DIN
DIN 7968
1989
English

Hexagon fit bolts for structural steel bolting for supply with or without nut

This standard specifies requirements for M 12 to M 30 hexagon fit bolts assigned to product grade C for use in structural steel bolting.
DIN
DIN 1624
1987
English

Cold reduced mild unalloyed steel strip in widths not exceeding 650mm – Technical delivery conditions

1.1 This standard applies to cold reduced flat products (strip and lengths cut from it), without coating, in widths not exceeding 650 mm and thicknesses up to 6mm, made from mild unalloyed steels as specified in table 1. The steels are suitable for forming and surface refinement, but not […]
3.01
ASTM
Abstract of ASTM A153/A153M
2000
English

ZINC COATING (HOT-DIP) ON IRON AND STEEL HARDWARE

1.1 This specification covers zinc coatings applied by the hot-dip process on iron and steel hardware. 1.2 This document is intended to be applicable to hardware items that are centrifuged or otherwise handled to remove excess galvanizing bath metal (free zinc). Coating thickness grade re […]
MIL
MIL-DTL-1222J
2000
English

STUDS, BOLTS, SCREWS AND NUTS FOR APPLICATIONS WHERE A HIGH DEGREE OF RELIABILITY IS REQUIRED

This specification covers standard studs, hex cap screws, and heavy hex bolts in nominal standard diameters of 1/4 inch to 4 inches, nuts in nominal standard diameters of 1/4 inch to 3 inches, and socket head cap screws in nominal standard diameters of 1/4 inch to 1-1/2 inches for submari […]