JIS B 1190

Hexagon nuts with flange

English 2005

0.000

Detailed Information

This Standard specifies the characteristics of hexagon nuts with flange.

If, in special cases, specifications other than those listed in this Standard are required, they should be selected from existing standards, for example JIS B 0205-2, JIS B 0209-2, JIS B 1052 and JIS B 1054-2.

NOTES
1 Hexagon nuts with flange not covered in ISO 4161 and ISO 10663 are specified in annex 1.
2 The International Standards corresponding to this Standard are as follows.

In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/IEC Guide 21.
ISO 4161: 1999 Hexagon nuts with flange — Coarse thread (MOD)
ISO 10663: 1999 Hexagon nuts with flange — Fine pitch thread (MOD)

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 46241-1

1956

English

Telecommunications Engineering – Contact Rivets – Solid or Clad – Technical Conditions of Delivery

These conditions of delivery apply to solid and clad contact rivets according to DIN 46240 Sheet 1 made of contact materials which can be shaped by nonoutting methods, e.g. silver , and contact carrier materials, e.g. copper for electrical purposes. Subject to agreement between manufacturer and u...

BS EN ISO

BS EN ISO 286-2

2010

English

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...

JIS

JIS B 1126

1995

English

Hexagon washer head tapping screws

This Standard specifies hexagon washer head tapping screws with threads from ST2.2 up to and including ST8.

ASME

ASME B18.1.1

2001

English

SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER

This standard covers complete general and dimensional data for those types of small solid rivets recognized as "American National Standard." All other types of small solid rivets, within the limits of the diameters contained herein, are to be considered special. Also included is an appendix cover...

DIN

DIN 6912

1985

English

Hexagon socket thin head cap screws with pilot recess for wrench key

This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to propert...

DIN

DIN 7349

1974

English

Plain Washers – for Bolts with Heavy Clamping Sleeves

For heavy clamping sleeves, see DIN 1481.