Check out other specifications
1956
English
Telecommunications Engineering – Contact Rivets – Solid or Clad – Technical Conditions of Delivery
These conditions of delivery apply to solid and clad contact rivets according to DIN 46240 Sheet 1 made of contact materials which can be shaped by nonoutting methods, e.g. silver , and contact carrier materials, e.g. copper for electrical purposes. Subject to agreement between manufacturer and u...
2010
English
Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)
This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...
1995
English
Hexagon washer head tapping screws
This Standard specifies hexagon washer head tapping screws with threads from ST2.2 up to and including ST8.
2001
English
SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER
This standard covers complete general and dimensional data for those types of small solid rivets recognized as "American National Standard." All other types of small solid rivets, within the limits of the diameters contained herein, are to be considered special. Also included is an appendix cover...
1985
English
Hexagon socket thin head cap screws with pilot recess for wrench key
This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to propert...