MIL-DTL-16232G

PHOSPHATE COATING, HEAVY, MANGANESE OR ZINC BASE

English 2000

0.000

Detailed Information

This specification covers two types of heavy phosphate coating for ferrous metals, applied by immersion. The coatings consist of a manganese phosphate or zinc phosphate base and, when specified, a supplementary treatment (see 6.1).

Download File

(Log in to download spec.)

Check out other specifications

DIN EN

DIN EN 28736

1992

English

Unhardened taper pins with internal thread (ISO 8736 : 1986) English version of DIN EN 28 736

This International Standard specifies the characteristics of unhardened taper pins with internal thread, and metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.

DIN

DIN 267-4

1983

English

Fasteners – Technical delivery conditions – Property classes for nuts (previous classes)

DIN 267 Part 4 was converted to the international property classes for nuts in 1967. The previous symbols 4D, 5D, 5S, 6G, 6S and 8G were replaced by code numbers 4, 5, 6, 8, 10, 12 and 14 where the code number indicated 1/100 of the minimum tensile strength of the bolt with which the nut […]

JIS

JIS B 1054-2

2001

English

Mechanical properties of corrosion-resistant stainless-steel fasteners — Part 2 : Nuts

This part of JIS B 1054 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic grades of corrosion- resistant stainless steels when tested over an ambient temperature range of 15 °C to 25 °C. Properties will vary at higher or lower temperatures.

IFI

IFI-156

2002

English

THUMB SCREWS AND WING SCREWS

This standard establishes the dimensional data for two types of thumb screws included in a regular and heavy series. Also included are wing screws in four types and two styles. Plain, cup, cone, oval, flat and dog points are also included.

DIN

DIN 609

1995

English

Hexagon fit bolts

This standard specifies dimensions and technical delivery conditions for M8 to M52 hexagon fit bolts, assigned to product grade A (for size M10 or less) or product grade B (for size M12 or greater). For hexagon fit bolts of sizes greater than M39, the specifications of this standard apply […]

DIN EN

DIN EN 26157-1

1991

English

Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)

1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nominal thread diameters 5 mm and larger; - product grades A and B; - property classes up to and inc […]