NASM 16995

SCREW, CAP, SOCKET HEAD-HEXAGON, CORROSION RESISTANT STEEL, UNC-3A

English 1998
0.000
NASM
Detailed Information

The minimum tensile strength in load pounds, indicated for each size in Table I, is based on 80.000 PSI minimum tensile strength. Load pounds are calculated by the stress areas indicated in FED-STD-H28/2. The yield strength, based on 0.2 percent offset, shall be 30.000 PSI minimum. The minimum hardness shall be HRB 80.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 977
1998
English

Hexagon weld nuts with flange

This standard specifies requirements for hexagon weld nuts with flange, with size M5 to M16 metric threads (coarse) or 12 mm to 16 mm diameter threads (fine), of product grade A. Weld nuts conf [...]
ISO
ISO 7047
1983
English

Cross recessed raised countersunk head screws (common head style) – Product grade A

This International Standard specifies the characteristics of cross recessed raised countersunk head screws with thread sizes from M 1,6 to M 10 inclusive. If other specifications are required, [...]
IFI
IFI-126
2008
English

BREAK MANDREL CLOSED END BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements of inch series break mandrel closed end blind rivets suitable for use in joining the component parts of an as [...]
DIN
DIN 137
1994
English

Wave spring washers

Spring lock washers as covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of a property class less than 5.8, as specified in [...]
ASTM
Abstract of ASTM F568M
1996
English

CARBON AND ALLOY STEEL EXTERNALLY THREADED METRIC FASTENERS

1.1 This specification covers chemical and mechanical requirements for nine property classes of carbon and alloy steel externally threaded metric fasteners in nominal thread diameters M1.6 thro [...]
DIN EN
DIN EN 28740
1992
English

Full-length parallel grooved pins, with chamfer (ISO 8740 : 1986) English version of DIN EN 28 740

This International Standard specifies the characteristics of full-length parallel grooved pins with chamfer which have three equally spaced grooves impressed longitudinally on their exterior su [...]