NASM 35275

SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A

English 1999
0.000
NASM
Detailed Information

DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F467M
1993
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for genera [...]
ASTM
ASTM F959M
1997
English

Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use With Structural Fasteners [Metric]

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural b [...]
DIN
DIN 561
1995
English

Hexagon set screws with small hexagon and full dog point

This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M56 hexagon set screws with small hexagon and full dog point, assigned to product gra [...]
DIN
DIN 7973
1970
English

Raised Countersunk (Oval) Head Tapping Screws with Slot

Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical condi [...]
DIN
DIN 1691
1985
English

Flake graphite cast iron (grey cast iron) Properties

In conjunction with the general technical delivery conditions specified in DIN 1690 Part 1, this standard specifies the properties of carbon and low alloy flake graphite cast iron (grey cast ir [...]
4.01
DIN
DIN 316
1983
English

Wing screws

In June 1975, drafts of the planned new editions of DIN 315 (wing nuts) and of DIN 316 (wing screws) were published; they made a distinction between Part 1 "heavy duty type" and Part 2 "light d [...]
DIN
DIN 6799
1981
English

Lock washers (retaining washers) for shafts

Lockwashers within the context of this standard are retaining washers for the axial retention of components on shafts. They are inserted radially in grooves and enclose the groove base under sp [...]
DIN EN
DIN EN 24034
1992
English

Hexagon nuts – Product grade C (ISO 4034 : 1986) English version of DIN EN 24 034

This International Standard gives specifications for hexagon nuts . with thread diameters from M5 to M64 inclusive and product grade C.
ASME
ABSTRACT OF ASME B1.1
2008
English

UNIFIED INCH SCREW THREADS (UN AND UNR THREAD FORM)

This Standard specifies the thread form, series, class, allowance, tolerance, and designation for unified screw threads. (In order to emphasize that unified screw threads are based on inch modu [...]