SAE J493
Rod Ends and Clevis Pins
English
1961
0.000
Detailed Information
The following publications form a part of the specification to the extend specified herein. Unless otherwise indicated the latest revision of SAE publications shall apply.
SAE J1010-Emission Control Hose
SAE J1111-Component Nomenclature-Skidder-Grapple
Download File
(Log in to download spec.)
Check out other specifications
1993
English
NONFERROUS NUTS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by […]
1997
English
Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use With Structural Fasteners [Metric]
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are co […]
1995
English
Hexagon set screws with small hexagon and full dog point
This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M56 hexagon set screws with small hexagon and full dog point, assigned to product grade A. These screws are only to be used as forcing screws (i.e. for adjusting and locating purpos […]
1970
English
Raised Countersunk (Oval) Head Tapping Screws with Slot
Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical conditions of delivery and material according to DIN 267 Sheet 12 (at present circulating as draft).
1985
English
Flake graphite cast iron (grey cast iron) Properties
In conjunction with the general technical delivery conditions specified in DIN 1690 Part 1, this standard specifies the properties of carbon and low alloy flake graphite cast iron (grey cast iron) in castings manufactured in sand moulds or moulds of comparable thermal diffusivity. The fol […]
4.01
1983
English
Wing screws
In June 1975, drafts of the planned new editions of DIN 315 (wing nuts) and of DIN 316 (wing screws) were published; they made a distinction between Part 1 "heavy duty type" and Part 2 "light duty type". This distinction did not however meet with general approval. because it did not refle […]